S10RX-V1.4 Updates 2026/06/09
2026-06-09 22:17:00
S10RX-V1.4
Release Date：2026/6/9 Updates：
1. Low Voltage Indication Optimization: When the supply voltage drops below 3.3V due to low battery voltage or BEC failure, the receiver no longer enters a protection state but instead indicates low voltage by flashing both red and blue LEDs simultaneously. Note: Low BEC voltage may cause other peripherals to malfunction; please check the battery level and charge promptly.
2. Firmware Update Confirmation Enhancement: In the receiver firmware update process, the original method required the user to press the receiver button to confirm. A new method has been added: bringing the transmitter close to the receiver also completes the confirmation, proceeding with the update. Both methods are supported.
3. New SN Code Support: The receiver now includes a serial number (SN). The transmitter will support SN reading starting from V0.23 and later versions.
4. Bug Fix for Issue Introduced in V1.3: When the transmitter and receiver were connected, holding the receiver button for 3 seconds to enter binding (BIND) mode could, in rare cases, prevent binding from completing normally. This issue has been resolved. It is strongly recommended that users with receivers on V1.3 update to the latest version.
Release Date：2026/6/9 Updates：
1. Low Voltage Indication Optimization: When the supply voltage drops below 3.3V due to low battery voltage or BEC failure, the receiver no longer enters a protection state but instead indicates low voltage by flashing both red and blue LEDs simultaneously. Note: Low BEC voltage may cause other peripherals to malfunction; please check the battery level and charge promptly.
2. Firmware Update Confirmation Enhancement: In the receiver firmware update process, the original method required the user to press the receiver button to confirm. A new method has been added: bringing the transmitter close to the receiver also completes the confirmation, proceeding with the update. Both methods are supported.
3. New SN Code Support: The receiver now includes a serial number (SN). The transmitter will support SN reading starting from V0.23 and later versions.
4. Bug Fix for Issue Introduced in V1.3: When the transmitter and receiver were connected, holding the receiver button for 3 seconds to enter binding (BIND) mode could, in rare cases, prevent binding from completing normally. This issue has been resolved. It is strongly recommended that users with receivers on V1.3 update to the latest version.